纺织学报 ›› 2017, Vol. 38 ›› Issue (06): 46-51.doi: 10.13475/j.fzxb.20160607806

• 纺织工程 • 上一篇    下一篇

立体编织石英纤维热密封环的气密性能

  

  • 收稿日期:2016-06-30 修回日期:2016-12-14 出版日期:2017-06-15 发布日期:2017-06-16

Gas tightmess characteristics of3-D braided sealing rings

  • Received:2016-06-30 Revised:2016-12-14 Online:2017-06-15 Published:2017-06-16

摘要:

为研究立体编织物直接应用作为热密封材料的气密性能。结合实际使用工况,选用石英纤维制作了纤维体积含量为50%的三维四向、三维五向及二维包芯3种编织结构的环状热密封制件。采用泄露实验分别对其进行了气密性能测试,得到了3种编织物在不同压差和不同压缩率下的气体容积流量,并计算出3种编织物在各个阶段的气体渗透率。研究结果表明:3种密封环的气密性能均达到密封要求。其气体渗透率随压差的增加而逐渐增加,但随压缩率的增大而逐渐减小。在相同条件下,三维整体结构织物气密性能优于二维包芯织物,其平均气体渗透率是二维织物的35.5%,且三维四向编织结构热密封环在各个阶段的气体渗透率均为最小,气密性能最好。

关键词: 热密封环, 三维编织结构, 气体渗透, 气密性

Abstract:

The gas tightness of the three-dimensional (3-D) braided preform as sealing material was studied. By cimbining actual situations, the braided sealing rings of three structures with fiber volume fraction of 50% were prepared from quartz fiber, which had 3-D 4-directional structure, 3-D 5-directional structure and 2-D core-spun structure. The gas leaking experiment was carried out to measure the gas tightness thereof to obtain the gas volume flows of the three kinds of braided fabrics on different pressure and at different compression ratio, and the gas permeability of the three kinds of braided fabrics at each stage was calculated, The Results show that all the three braided sealing rings reach the sealing requirements, and the gas permeability gradually increases with the increase of the pressure difference, but decreases with the increase of compression ratio. Moreover, the gas permeability of the 3-D braided sealing rings is much better than that of the 2-D core fabric, and the average gas permeability is 35.5% of the 2-D core-spun fabric. The 3-D 4-directional braided annular thermal seal ring shows the lowest gas permeability and exhibit the base gas tightness.

Key words: sialing ring, 3-D braided structure, gas permeability, gas tightness

中图分类号: 

  • TB332
[1] 宋磊磊 赵玉芬 李嘉禄 陈利 耿伟. 基于混合韦伯分布的碳纤维针刺毡结构表征[J]. 纺织学报, 2017, 38(06): 52-57.
[2] 楼利琴 任烨烨 傅雅琴. 竹原纤维/聚氨酯复合材料的力学性能[J]. 纺织学报, 2015, 36(11): 63-0.
[3] 张雪 陈韶娟 孙亚宁 张潭 马建伟 孙晓婷. 应用三维扫描技术的织物成型性测试与表征[J]. 纺织学报, 2014, 35(12): 63-0.
[4] 陶宇 沈娟娟 李树白 陈海群 纪俊玲 聂华丽 赵昊昱. 碳纳米管/CeO2静电自组装制备及其抗紫外线性能[J]. 纺织学报, 2014, 35(10): 7-0.
[5] 徐艺榕 孙颖 韩朝锋 陈利 李嘉禄 潘宁. 复合材料用三维机织物成型性的研究进展[J]. 纺织学报, 2014, 35(9): 165-0.
[6] 孙西超 李艳清 詹小芳 刘双双 祝成炎. 剪切黏稠液体的制备及其性能[J]. 纺织学报, 2014, 35(8): 5-0.
[7] 卢子兴 周原 陈明阳 夏彪. 用于缎纹机织复合材料力学行为数值模拟的新单胞模型[J]. 纺织学报, 2014, 35(5): 40-0.
[8] 汪泽幸 蒋金华 陈南梁. 反复加载下机织物增强柔性复合材料的力学行为[J]. 纺织学报, 2014, 35(1): 51-0.
[9] 曹海建 钱坤 徐文新 李雅 臧红. 三维全五向编织复合材料的压缩性能[J]. 纺织学报, 2013, 34(8): 68-0.
[10] 徐艳华 袁新林. 玄武岩纤维机织针织复合织物增强复合材料的弯曲性能[J]. 纺织学报, 2013, 34(1): 36-39.
[11] 蒋岩岩 秦静雯 钱伟伟 傅佳佳 王鸿博. 载药聚乳酸/丝素纳米纤维的制备及缓释性能[J]. 纺织学报, 2012, 33(11): 15-19.
[12] 汪泽幸, 蒋金华, 陈南梁. 织物增强柔性复合材料的缺口敏感性[J]. 纺织学报, 2012, 33(1): 54-59.
[13] 万振凯 李嘉禄 李怡. 光纤布拉格光栅在复合材料连续状态健康监测中的应用[J]. 纺织学报, 2011, 32(8): 57-61.
[14] 朱曜峰;王艳;傅雅琴. 二氧化钛/碳纤维多孔薄膜的制备及催化性能[J]. 纺织学报, 2011, 32(4): 23-28.
[15] 徐艳华;袁新林;胡红. 玄武岩纤维机织针织复合结构增强复合材料的拉伸性能[J]. 纺织学报, 2011, 32(2): 48-52.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!