纺织学报 ›› 2021, Vol. 42 ›› Issue (01): 67-72.doi: 10.13475/j.fzxb.20200303806

• 纺织工程 • 上一篇    下一篇

基于可调张力装置的芳纶织物交织阻力研究

陈洁如1, 邱诗苑1, 杨青青1, 周熠1,2()   

  1. 1.武汉纺织大学 纺织科学与工程学院, 湖北 武汉 430200
    2.武汉纺织大学 纺织纤维及制品教育部重点实验室, 湖北 武汉 430200
  • 收稿日期:2020-03-16 修回日期:2020-09-30 出版日期:2021-01-15 发布日期:2021-01-21
  • 通讯作者: 周熠
  • 作者简介:陈洁如(1985—),女,硕士生。主要研究方向为弹道防护材料及其力学分析。
  • 基金资助:
    国家自然科学基金青年科学基金项目(11502179);湖北省教育厅科学研究计划项目(D20171602)

Research on inter-yarn friction of aramid fabric based on adjustable tension device

CHEN Jieru1, QIU Shiyuan1, YANG Qingqing1, ZHOU Yi1,2()   

  1. 1. College of Textile Science and Engineering, Wuhan Textile University, Wuhan, Hubei 430200, China
    2. Key Laboratory of Textile Fiber & Product, Ministry of Education, Wuhan Textile University, Wuhan, Hubei 430200, China
  • Received:2020-03-16 Revised:2020-09-30 Online:2021-01-15 Published:2021-01-21
  • Contact: ZHOU Yi

摘要:

为更加真实地模拟芳纶织物在受到冲击时产生的交织阻力变化情况,通过构建一个半经验模型来预测对于不同规格、不同预加张力情况下纱线交织阻力的数值,并设计了可调预加张力的纱线抽拔实验用夹具,分别以织物的经向宽度、纬向宽度和预加张力为变量对纱线进行抽拔实验。实验结果表明:对织物施加横向预加张力与纱线抽拔时的交织阻力呈正相关,预加张力逐渐增大时,织物纬向宽度对交织阻力的影响逐渐增强;反之,交织阻力随着织物的经向宽度的增加会逐渐减小,而相较于经向宽度的影响,织物预加张力对于交织阻力的影响显得更为突出。

关键词: 预加张力, 织物交织阻力, 单纱抽拔, 半经验模型公式, 芳纶织物, 防弹衣

Abstract:

In order to simulate the inter-yarn friction in aramid fabrics under impact loading and to construct a model for predicting the inter-yarn friction under different fabric specifications and pre-tension levels, a fixture with adjustable transverse pre-tension for yarn-pulling experiment was created. The yarn pulling-out experiments were carried out using different widths of warp yarns or weft yarns and pre-tension as variables. The test results show that there is a positive correlation between the transverse pre-tension applied to the fabric and the inter-yarn friction. When the pre-tension increases, the influence of the warp width of the fabric on the inter-yarn friction increases gradually, and the inter-yarn resistance gradually decrease as sample warp width increases. The effect of pre-tension on inter-yarn friction is more prominent than that of the sample warp width.

Key words: pre-tension, inter-yarn friction, single yarn-pulling, semi-empirical model formula, aramid fabric, bulletproof vest

中图分类号: 

  • TB334

图1

可调横向预加张力的织物夹具图 ①—左夹钳;②—安装框;③—纱尾;④—右夹钳;⑤—传感器;⑥—带弹簧的螺栓;⑦—光滑槽口;⑧—夹具底座。"

图2

织物交织阻力以及横向张力与被抽拔纱线纵向位移关系图"

表1

13 cm×12 cm织物在不同预加张力下交织阻力的最值"

预加张力/N 交织阻力/N 差值(最终值-
初始值)/N
最大值 最小值
100 102.9 99.8 -0.2
200 208.3 198.4 -1.6
300 308.6 298.3 -1.7
400 410.5 398.6 -1.4

图3

8 cm×8 cm平纹机织物抽拔实验交织阻力-位移曲线"

图4

绞盘方程的示意图"

图5

400 N预加张力下不同经向宽度织物的交织阻力曲线"

图6

不同预加张力下不同经向宽度织物最大交织阻力对比图"

图7

300 N预加张力下不同纬向宽度织物的交织阻力曲线"

图8

不同预加张力下不同纬向宽度织物最大交织阻力对比图"

图9

交织阻力的拟合图"

[1] BAZHENOV S. Dissipation of energy by bulletproof aramid fabric[J]. Journal of Material Science, 1997,32:4167-4173.
[2] NILAKANTAN G, MERRILL R L, KEEFE M, et al. Experimental investigation of the role of frictional yarn pull-out and windowing on the probabilistic impact response of Kevlar fabrics[J]. Composites Part B, 2015,68:215-229.
[3] 周熠, 张尚勇, 龚小舟, 等. 摩擦对平纹织物防弹性能影响的研究进展[J]. 纺织学报, 2016,37(8):160-164.
ZHOU Yi, ZHANG Shangyong, GONG Xiaozhou, et al. Research progress on the effect of friction on the bulletproof performance of plain weave fabrics[J]. Journal of Textile Research, 2016,37(8):160-164.
[4] KIRKWOOD K M, WETZEL E D, KIRKWOOD J E, et al. Yarn pull-out as a mechanism for dissipating ballistic impact energy in Kevlar KM-2 fabric: part 2: prediction of ballistic performance[J]. Textile Research Journal, 2004,74(10):920-928.
[5] ZHOU Yi, MUHAMMAD A, GONG Xiaozhou, et al. An overview on yarn pull-out behaviour of woven fabrics[J]. Textile Research Journal, 2019,89(2):223-234.
[6] ZHU D, SORANAKOM C, MOBASHER B, et al. Experimental study and modeling of single yarn pull-out behavior of Kevlar 49 fabric[J]. Composites Part A: Applied Science and Manufacturing, 2011,42(7):868-879.
[7] BILISIK K, YOLACAN G. Single and multiple yarn pull-out on e-glass woven fabric structures[J]. Textile Research Journal, 2011,81(19):2043-2055.
[8] 王江洪, 苏辉, 孙波, 等. 螺栓-法兰连接系统的应力松弛[J]. 汽轮机技术, 2000,42(1):24-26.
WANG Jianghong, SU Hui, SUN Bo, et al. Stress relaxation of the bolt and flange connecting system[J]. Steam Turbine Technology, 2000,42(1):24-26.
[9] HOWELL H G, MIESZKIS K W, TABOR D. Friction in textiles[J]. Nature, 1959,1765(184):47.
[10] KHAN Monir, MUHAMMAD Ali, 方小银, 等. 纱罗组织对芳纶织物交织阻力的影响[J]. 纺织学报, 2018,39(11):38-44.
KHAN Monir, MUHAMMAD Ali, FANG Xiaoyin, et al. Influence of leno structure on yarn gripping behaviour of aramid plain weave[J]. Journal of Textile Research, 2018,39(11):38-44.
[1] 李美真, 赵士毅, 冯艳丽, 郭晓卿, 于晓庆. F-12 芳纶织物输送带的制备及其性能[J]. 纺织学报, 2020, 41(12): 87-93.
[2] 马飞飞. 离散树脂成型复合材料的防刺与服用性能[J]. 纺织学报, 2020, 41(07): 67-71.
[3] 李聃阳, 王瑞, 刘星, 张淑洁, 夏兆鹏, 阎若思, 代二庆. 剪切增稠液对不同结构芳纶织物防刺性能的影响[J]. 纺织学报, 2020, 41(03): 106-112.
[4] 敖利民 及二丽 莫晓旋 李向阳 李春钢. 空气网络包覆弹力纱中氨纶丝实际预牵伸倍数测试[J]. 纺织学报, 2017, 38(11): 36-40.
[5] 刘晓艳;于伟东. 溶胶-凝胶改善芳纶织物的耐光性[J]. 纺织学报, 2009, 30(02): 84-88.
[6] 林兰天;周静. 减少防弹衣非贯穿性损伤的方法探讨[J]. 纺织学报, 2004, 25(06): 87-89.
[7] 熊杰;施楣梧;周国泰;王善元. 芳纶织物—树脂复合材料的动态拉伸实验研究[J]. 纺织学报, 2000, 21(05): 39-41.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!