纺织学报 ›› 2010, Vol. 31 ›› Issue (2): 27-32.

• 纺织工程 • 上一篇    下一篇

网格圈型集聚纺集聚区工艺参数对集聚效果的影响

汪燕;华志宏;程隆棣;薛文良

  

  • 收稿日期:2009-01-15 修回日期:2009-06-05 出版日期:2010-02-15 发布日期:2010-02-15
  • 通讯作者: 程隆棣

Influence of processing parameters on quality of fiber compact in condensing zone of compact spinning with lattice apron

WANG Yan;HUA Zhihong;CHENG Longdi;XUE Wenliang   

  • Received:2009-01-15 Revised:2009-06-05 Online:2010-02-15 Published:2010-02-15

摘要:

为获得负压大小、网格圈外表面摩擦因数对集聚区集聚效果的影响,建立集聚区流体动力学模型,分析了集聚区域内气流的流动状况,在其他条件相同的基础上,采用自编的Matlab编程模拟不同负压及相同负压不同摩擦因数下对应位置处单纤维在集聚区的运动轨迹。研究结果表明:负压大小和网格圈外表面摩擦因数均对集聚效果有影响,在二者取值较小时,集聚效果随着取值的增加相应有不同程度的改善,达到各自的最佳集聚状态后,取值增加使得集聚效果恶化。

Abstract:

To get the effect of different negative pressures and friction factor of lattice apron at the outer surface on fiber compact in condensing zone of compact spinning with lattice apron, computational fluid dynamic model was established, and flowing state of airflow were characterized in convergence zone. Previded that other conditions were fixed, the trajectories of fibers at the counterpart positions were different and when negative pressures were the same but friction factors were different with the lattice apron at the outer surface. The results show that both the negative pressure and friction factor of lattice apron at the outer surface have great impact on the compact effect. Increasing these two values from the lower ends, the campact quality is improved. However, after reaching the optimal compact effect, further increasing the two values would lead to the opposite result.

No related articles found!
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!