纺织学报 ›› 2017, Vol. 38 ›› Issue (09): 32-39.doi: 10.13475/j.fzxb.20160805308

• 纺织工程 • 上一篇    下一篇

复合纱体中长丝分布形态对纱线性能的影响

  

  • 收稿日期:2016-08-24 修回日期:2017-03-30 出版日期:2017-09-15 发布日期:2017-09-20

Influence of filament distribution pattern on properties of composite yarns

  • Received:2016-08-24 Revised:2017-03-30 Online:2017-09-15 Published:2017-09-20

摘要:

为研究长丝复合纺纱过程中由长丝与短纤维须条复合产生的不同纱线内部结构对纱线性能的影响,设计并建立了6种长丝复合纺纱线结构模型,分析和预测了模型对应的成纱性能,并进行实验验证,对比分析了各复合纺纱形式所得纱线的毛羽、条干、强伸性能。结果表明:相比单独的包芯结构和长丝单侧包缠结构,长丝由两侧对须条进行包缠优化了纱线结构,表现出更佳的复合纱拉伸和成纱条干性能;同时拥有长丝双侧包缠和包芯结构的复合纱,表现出最优的成纱强力和条干;较大的长丝与须条隔距与张力更有利于长丝束缚和控制纤维外露,有效降低成纱毛羽。

关键词: 长丝复合纺纱, 纱线结构模型, 纱线性能, 长丝分布, 双包缠结构

Abstract:

To analyze the influence of inner structural changes on composite yarn properties during the varied filament composite spinning by changing the filaments and the roving positions, six different structures of composite yarn models were systematically designed and built to analyze and predict the properties of the corresponding yarns. Different structural composite yarns were produced experimentally to verify the composite yarn models. Different composite yarn properties including hairiness, evenness and tensile properties were compared and analyzed. The results show that the composite yarn with filaments wrapping from both sides of the strand had better evenness and higher tenacity than that of yarns with single core-filament spun structure. When the composite yarns had both bilateral wrapping and core-filament structures, an optimized yarn strength and evenness are owned. The increased filament tension and filament-strand spacing could effectively enhance the short fiber control and reduce composite yarn hairiness.

Key words: filament composite spinning, yarn structure model, yarn property, filament distribution, bothbilateral wrapping structure

[1] 吴娟 谢春萍 徐伯俊 刘新金 苏旭中. 和毛油添加对牦牛绒纤维及成纱质量的影响[J]. 纺织学报, 2015, 36(12): 32-0.
[2] 钟智丽 王玉新. 聚丙烯长丝/芳纶包缠纱捻度的优化[J]. 纺织学报, 2014, 35(6): 40-0.
[3] 付江;于伟东. 假捻集聚纺纱方法中基本工艺参数的作用分析[J]. 纺织学报, 2011, 32(5): 38-42.
[4] 华涛;陶肖明;郑国宝;黄家祺;徐宾刚. 机织用扭妥TM纱的应用研究[J]. 纺织学报, 2004, 25(05): 38-39.
[5] 王虹云;魏培锋. 针织用纱的生产过程[J]. 纺织学报, 2002, 23(05): 55-56.
[6] 马会英. 玻璃纤维空气变形纱的研制与性能分析[J]. 纺织学报, 2002, 23(05): 63-64.
[7] 江慧;付培华. Solospun纺纱技术及纱线结构分析[J]. 纺织学报, 2002, 23(02): 33-34.
[8] 吴雄英;王府梅;王善元. 复合纱结构及其基本力学性能、表面性能的研究[J]. 纺织学报, 1998, 19(04): 21-24.
[9] 侯仁澄;郑国宝;宁福君;王盛琪;王善元. 捻度对ATY缝纫线性能的影响[J]. 纺织学报, 1998, 19(04): 61-65.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!