纺织学报 ›› 2018, Vol. 39 ›› Issue (07): 27-31.doi: 10.13475/j.fzxb.20170905806

• 纺织工程 • 上一篇    下一篇

假捻器在环锭细纱机上的应用效果及工艺优化

  

  • 收稿日期:2017-09-27 修回日期:2018-04-08 出版日期:2018-07-15 发布日期:2018-07-16

Application and process optimization of false twist in ring spinning machine

  • Received:2017-09-27 Revised:2018-04-08 Online:2018-07-15 Published:2018-07-16

摘要:

为更好地提高棉纤维的成纱性能,利用自主研发的假捻装置,在加装假捻装置的环锭细纱机上分别控制装置的速度、位置和纺纱方式,纺制了28.1 tex 棉纱,并对成纱质量进行了测试分析。测试结果表明:假捻器在纺纱过程中的最优转速为300 r/min,速度过大或过小都会影响纱线的强力和毛羽;假捻点与前罗拉钳口的连线和水平线之间夹角的正切值为0.7 时成纱效果最佳,假捻器的位置可改变纱路进而影响加捻三角区的大小和状态,纺纱过程中优选假捻器的合适位置有利于提高成纱质量;假捻器与斜位纺结合使用,改善了单一假捻纺纱情况下的纱线性能。

关键词: 假捻器, 低捻高强棉纱, 纺纱加捻三角区, 斜位纺, 环锭细纱机

Abstract:

In order to improve the spinning performance of cotton fiber, 28.1 tex yarn was spun by controlling the speed, position and spinning mode of the device on the rung spinning machine equipped with false twisting device. The quality of the yarn was tested and analyzed. The experimental result shows that the optimal speed of the false twister is 300 r/min during spinning. The strength and hairiness of the yarn will be affected if the speed is too large or too small. When the tangent between the false twisting point and front roller nip connection and horzontal line is 0.7, yarn eith the optimal quality can be spun. False twister position can change the yaran path, thus affecting the size and state of the twisting triangle. Preferred position of the false twister during spinning is beneficial to improve yarn quality. The combinationof false twister and oblique spinning improves the yarn performance under the condition of single false twist spinning.

Key words: false twister, cotton yarn with low twist high strength, spinning twist triangle, oblique spinning, ring spinning machine

[1] 路明娜 程隆棣 董国虎 方斌. 集聚赛络假捻纱与集聚赛络纱的性能对比[J]. 纺织学报, 2017, 38(12): 38-42.
[2] 余豪 张建建 刘可帅 陈军 夏治刚. 导纱钩运动引起的纺纱三角区变化对成纱性能的影响[J]. 纺织学报, 2016, 37(10): 19-25.
[3] 朱洋 陈革 薛元. 彩虹段彩纱构造针织物图案的机制及其设计软件开发[J]. 纺织学报, 2016, 37(08): 47-53.
[4] 付江;于伟东. 假捻集聚纺纱方法中基本工艺参数的作用分析[J]. 纺织学报, 2011, 32(5): 38-42.
[5] 杨昆;陶肖明;徐宾刚;林国昌. 假捻对低捻环锭纱结构的影响[J]. 纺织学报, 2008, 29(4): 37-42.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!