梳针刺辊梳棉机落棉的实验分析

纺织学报 ›› 2005, Vol. 26 ›› Issue (4): 97-99.

梳针刺辊梳棉机落棉的实验分析

王兰¹,孙鹏子¹,张明光¹,邹健敏²

1.辽东学院辽宁丹东118003 ;2.大连轻工业学院辽宁大连116036

收稿日期:1900-01-01 修回日期:1900-01-01 出版日期:2005-08-15 发布日期:2005-08-15

Test & analysis of droppings with gill pin licker-in carding machine

WANG Lan1;SUN Peng-zi1;ZHANG Ming-guang1;ZOU Jian-min2

1.Liaodong College;Dandong;Liaoning 118003;China; 2.Dalian Institute of Light Industry;Dalian;Liaoning 116036;China

Received:1900-01-01 Revised:1900-01-01 Online:2005-08-15 Published:2005-08-15

摘要/Abstract

摘要： 就梳针式刺辊梳棉机落棉率进行了实验研究,着重研究了不同工作角度的梳针刺辊与锯齿刺辊在不同速度下梳棉机落棉率的变化情况。结果证实,梳针工作角对梳针式刺辊梳棉机落棉率有一定影响,梳针工作角在66～58°间落棉率与锯齿刺辊落棉率相差不大,而梳针工作角在73°时落棉率明显高于锯齿刺辊。梳针表面光滑及摩擦因数小是梳针式刺辊落棉率较高的根本原因。

Abstract: The test & research of droppings rate were carried on with gill pin licker-in carding machine.The change of droppings rate was mainly studied by different working angles of gill pin licker-in and saw-toothed licker-in at different working speeds.As a result of the experiments,the working angles of gill pin have certain influence on droppings rate of gill pin licker-in carding machine.When the working angles are between 58 and 66 degrees,there are almost no difference between its droppings rate and that of saw-toothed licker-in.However,when the working angle of gill pin is at 73 degrees,its droppings rate is obviously higher than that of saw-toothed licker-in.Smooth surface of gill pin and small friction coefficient are essential reasons for higher droppings rate of gill pin licker-in carding machine.

王兰;孙鹏子;张明光;邹健敏. 梳针刺辊梳棉机落棉的实验分析[J]. 纺织学报, 2005, 26(4): 97-99.

WANG Lan;SUN Peng-zi;ZHANG Ming-guang;ZOU Jian-min. Test & analysis of droppings with gill pin licker-in carding machine[J]. JOURNAL OF TEXTILE RESEARCH, 2005, 26(4): 97-99.

参考文献

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed