纺织学报 ›› 2011, Vol. 32 ›› Issue (11): 28-32.

• 纺织工程 • 上一篇    下一篇

玻璃纤维∕涤纶混杂热塑性机织复合材料的制备及其性能

叶飞1,田伟1,冯兆行2,陈平磊1,祝成炎1   

  1. 1. 浙江理工大学
    2. 浙江理工大学材料与纺织学院
  • 收稿日期:2011-01-10 修回日期:2011-06-17 出版日期:2011-11-15 发布日期:2011-11-15
  • 通讯作者: 叶飞 E-mail:yefei510@126.com
  • 基金资助:

    省级

The preparation and properties research of GF/PET hybrid woven thermoplastic composite

  • Received:2011-01-10 Revised:2011-06-17 Online:2011-11-15 Published:2011-11-15

摘要: 利用PP作为基体,GF和PET为增强纤维织成的机织平纹预制件,采用层合热压法制备热塑性复合材料板材。并以此为基础研究了复合材料中PP体积含量对板材厚度、截面形貌、树脂浸渍增强纤维的效果以及对板材拉伸性能的影响。结果表明:随着PP含量的增加,复合材料板材的厚度呈明显下降趋势,当PP含量超过60%时,复合材料厚度的变化逐渐趋于平缓;随着PP含量的增加,树脂对增强纤维包覆和浸渍效果越来越好,但由于增强纤维相对量的减少则会导致力学性能下降。

Abstract: Utilizing PP as matrix,GF and PET as reinforcing fibers,preform of plain fabric were woven and the thermoplastic composites were made by the hot pressing of lamination.On the basis of these composite samples,this paper studied the influence of the PP volume content on the thickness,the cross-section morphology,the impregnating degree of the resin and the tensile properties of composite sheet.The results indicate that: when the content of PP increases,the tendency for the thickness of the composite sheet will be downward clearly,while when the content of PP is over 60%,the change of the thickness will tend to be gentle.The content of PP is greater,the effect of resin coats and soaks reinforcing fibers is the better.However,the mechanical properties will be declined with the relative amount of reinfored fibers decreased.

No related articles found!
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!