纺织学报 ›› 2016, Vol. 37 ›› Issue (08): 41-46.

• 纺织工程 • 上一篇    下一篇

喷气织机车速对织物纬向物理力学性能的影响

  

  • 收稿日期:2015-09-28 修回日期:2016-03-11 出版日期:2016-08-15 发布日期:2016-08-05

Influence of air-jet loom speed on weft physical and mechanical properties of fabrics

  • Received:2015-09-28 Revised:2016-03-11 Online:2016-08-15 Published:2016-08-05

摘要:

为研究织物纬向物理力学性能与喷气织机车速的关系,测试了不同车速织机生产织物两侧的捻度差异。采用分段拆纱取样法分别对不同车速下所织织物纬纱两侧捻度及强伸性、织物强伸性、抗弯长度及染色性能进行测试与分析。结果表明:车速越低,纬纱退捻产生问题越多,织物两侧色差越大;车速越高,纬纱飞越梭口时处于无握持状态时间越短,纬纱退捻量减少,织物两侧纬纱捻度、强力损失减小,废边侧织物断裂强力及抗弯刚度损失减小,织物两侧染色效果变化较小,但车速增加对原纱要求提高,因此,选择合适车速,是喷气引纬提高产质量的关键。

关键词: 喷气织机, 车速, 捻度, 物理力学性能, 差异性

Abstract:

In order to study the relationship between the physical mechanical properties of fabrics and air-jet loom speed, the twist difference on both sides of the fabrics at different weaving loom speed(500r/min、600r/min、700r/min)is analyzed in this paper. Samples of the fabrics are selected by ravel weft yarns on the different part, and the twist distribution, the weft strength and elongation, the fabric strength and elongation, the fabric bending length, and the fabric dyeing properties of each weft yarn sections were tested separately under different speed. The experiment result shows that the weft yarn untwisting generate more problems and difference between both sides of the color is bigger when the speed is lower. On the contrary, the increasing of the weft speed will decrease the weft yarn freely flying time, the untwist degree of the weft yarn was decreased with the shorten of weft yarn insertion time, and the weft strength loss, the fabric breaking strength loss, the bending rigidity loss, the dyeing difference on both side of the fabrics was decreased as well, but raw yarn quality requirements were improved with the speed simultaneously. Therefore, proper appropriate speed is the key to improve the quality and output of production by air-jet weft insertion.

Key words: air-fet loom, loom speed, twist, hysical and mechanical property, difference

[1] 胥光申 孔双祥 刘洋 罗时杰. 基于Fluent的喷气织机辅助喷嘴综合性能[J]. 纺织学报, 2018, 39(08): 124-129.
[2] 颜苏芊 王力平. 喷气织机中压缩空气的泄漏评估及其修复优化[J]. 纺织学报, 2018, 39(04): 130-136.
[3] 韩要宾 张杰 高卫东 潘如如 张宁. 基于生产实践的喷气织机主喷嘴气压优选[J]. 纺织学报, 2017, 38(01): 126-131.
[4] 张敏 王鸿博 高卫东 陈巧兰. 喷气织机辅助喷嘴流场特性与耗气量分析[J]. 纺织学报, 2016, 37(12): 123-128.
[5] 张亮 冯志华 张晓飞 刘帅. 喷气织机辅助喷嘴与异形筘结构参数对流场的影响[J]. 纺织学报, 2016, 37(09): 129-133.
[6] 金玉珍 胡小冬 林培锋 胡旭东. 喷气织机打纬机构及墙板的振动特性[J]. 纺织学报, 2016, 37(07): 131-136.
[7] 张亮 冯志华 刘帅 陈亮 张晓飞. 喷气织机辅助喷嘴喷孔结构优化设计[J]. 纺织学报, 2016, 37(06): 112-117.
[8] 钟智丽 王玉新. 聚丙烯长丝/芳纶包缠纱捻度的优化[J]. 纺织学报, 2014, 35(6): 40-0.
[9] 董腾中 冯志华 王卫华 陈亮 刘帅. 喷气织机主喷嘴引纬流场数值模拟与实验验证[J]. 纺织学报, 2014, 35(5): 126-0.
[10] 李新荣 蒋秀明 杨建成 王晓维. 基于纤维断裂的棉精梳机“柔性精梳”分析[J]. 纺织学报, 2013, 34(9): 130-0.
[11] 徐海燕. 捻度对超高分子质量聚乙烯纱线可编织性的影响[J]. 纺织学报, 2013, 34(11): 44-0.
[12] 徐存强 冯志华 董腾中 王卫华 卞亚东. 气流引纬主喷嘴内气流速度与纬纱间摩擦因数的关系[J]. 纺织学报, 2013, 34(11): 147-0.
[13] 崔红, 肖志永, 郁崇文. 自捻纱的捻度分布特征分析[J]. 纺织学报, 2012, 33(8): 40-45.
[14] 谭保辉, 冯志华, 刘丁丁, 唐银萍. 基于CFD的喷气织机辅助喷嘴流场分析[J]. 纺织学报, 2012, 33(7): 123-128.
[15] 缪旭红, 刘洁琼. 玻璃纤维经编成圈编织性能[J]. 纺织学报, 2012, 33(2): 35-39.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!