纺织学报

• 纺织工程 • 上一篇    下一篇

纯棉织物折皱回复角与其组织结构参数的关系

  

  • 出版日期:2017-04-15 发布日期:2017-04-15

Relationship bepure cotton fabruc's wrinkle recovery angle and its organizatonal structure parameters

  • Online:2017-04-15 Published:2017-04-15

摘要:

为从织物自身组织结构方面优化纯棉织物的折皱性,首先设计织物组织结构参数并制备织物,利用数字式织物折皱弹性仪测得织物的折皱回复角。在此基础上,建立纯棉织物经、纬向和总折皱回复角与织物组织结构参数(包括经纬纱线密度、经纬纱捻度、经纬向密度)之间的线性回归方程;同时分析织物折皱回复角与各组织结构参数间的相关性。结果表明:回归方程的计算值与折皱回复角实测值绝对误差不超过0.61°,回归方程具有较高的实用性;经纬纱捻度、线密度对纯棉织物的折皱回复性影响最大,可通过提高经纬纱捻度、降低经纬纱线密度来改善纯棉织物的抗皱性。

关键词: 集聚纺, 纯棉织物, 折皱回复角, 组织结构参数, 多元线性回归

Abstract:

In order to potimize the crease propety of pure cotton fabric from its weave structure, fiestly,fabric's weave structure parameters were designed and fabrics were woven, then the winkle recovery angles were measured by digital wrinkle-recovery tester. On this basis, the linear regression equations among the fabric's warp, weft and total wrinkle recovery angles weave structure parameters were established, which included warp and weft yarn linear density, warp and weft yarn twist, warp density and weft density. The relationship between fabric's wrinkle recovery angle and weave structure parameters was analyzed. The results indicate that the absolute error of the regression equation between calculated values and measured values about wrinkle recovery angle is smaller than 0.61°, and the regression equation bas gigher practicability. Warp and weft yarn twist, warp and weft yarn linear density have the greatest impact on fabric's cerase recovery, and gence the fabrec's crease resistance can be improved by increasing the yarn twist and reducing the yarn linear density.

Key words: compact spinning, pure cotton fabric, wrinkle recovery angle, weave structure parameter, multiple linear regression

[1] 刘可帅 江伟 杨圣明 郭维琪 夏治刚 倪俊龙 徐卫林. 多重集聚纺纱结构成形机制及其针织物性能[J]. 纺织学报, 2018, 39(02): 26-31.
[2] 刘成霞 韩永华. 模拟实际着装的织物抗皱性测试方法[J]. 纺织学报, 2017, 38(03): 56-60.
[3] 黄张秘 周翔 邢志奇 张文龙. 棉织物的聚羧酸无甲醛免烫整理[J]. 纺织学报, 2017, 38(01): 94-99.
[4] 汪兴锋 徐伯俊 苏旭中 陈松 戴家雨. 集聚纺系统在绢纺细纱机中的应用[J]. 纺织学报, 2016, 37(4): 124-0.
[5] 刘成霞 刘婷. 应用小波分析的服装关节部位抗皱性评价[J]. 纺织学报, 2016, 37(12): 87-91.
[6] 黄三娇 高卫东 王鸿博. 精纺毛织物结构参数与折皱回复性的关系[J]. 纺织学报, 2016, 37(11): 37-41.
[7] 刘宇 沈一峰 杨雷. 新型无甲醛防皱整理剂BTP400在棉织物上的应用[J]. 纺织学报, 2016, 37(08): 77-82.
[8] 张月 王蕾 刘建立 高卫东. 试验参数对棉织物回复角测试结果的影响[J]. 纺织学报, 2015, 36(08): 33-37.
[9] 宋玉 吴敏 计丽虹 王平. 紫外光固化聚氨酯膜的制备及其在棉织物涂层整理中的应用[J]. 纺织学报, 2014, 35(6): 89-0.
[10] 王蕾 刘建立 潘如如 高卫东. 基于视频序列的织物折皱回复角动态测量[J]. 纺织学报, 2013, 34(2): 55-60.
[11] 赵立环 张杰. 织物折皱回复角与其力学性能指标间的关系[J]. 纺织学报, 2013, 34(10): 39-0.
[12] 刘成霞, 徐晶. 基于图像处理的织物多方向抗皱性测试方法[J]. 纺织学报, 2012, 33(7): 48-52.
[13] 王健 张晓丽 刘陶. 机织物透气性预测的投影寻踪回归模型[J]. 纺织学报, 2011, 32(8): 46-49.
[14] 付江;于伟东. 假捻集聚纺纱方法中基本工艺参数的作用分析[J]. 纺织学报, 2011, 32(5): 38-42.
[15] 刘玉磊;孟家光;胡海霞. 竹浆纤维的防缩抗皱整理[J]. 纺织学报, 2011, 32(3): 91-94.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
No Suggested Reading articles found!