Journal of Textile Research ›› 2018, Vol. 39 ›› Issue (11): 150-157.doi: 10.13475/j.fzxb.20171204208

Previous Articles     Next Articles

Theoretical and experimental analysis on heat transfer performance of dew point indirect evaporative cooler

  

  • Received:2017-12-20 Revised:2018-08-07 Online:2018-11-15 Published:2018-11-19

Abstract:

In view of the optimization of the dew point indirect evaporative cooler structure, the cooling efficiency under different environmental conditions, the relationship between the air volume ratio and the cooling capacity, and the technical principle, structure, heat and mass transfer characteristics of three different dew point indirect evaporative coolers (composite , cross and countercurrent ) were compared and analyzed. At the same time, the three kinds of dew point indirect evaporative cooler were tested on the wet bulb efficiency, dew point efficiency, temperature drop range, cooling capacity and so on under the laboratory simulation conditions or practical applications. The experimental results show that under dry conditions, the wet bulb efficiency of the three dew point coolers can all reach above 100%, and the dew point efficiency is between 55% and 85%. In terms of the temperature drop range, the average dry-bulb temperature drop of the cross-type and composite dew-point coolers under standard drying conditions (dry bulb temperature of 38°℃and wet bulb temperature of 23℃) is about 15 °℃, and wet bulb temperature drop is at about 5.5 ℃, significantly better than that of the composite dew point cooler. At this point, the countercurrent dew point cooler energy effciency raio is 11.78, reaching the highest level.

Key words: dew point indirect evaporative cooling, heat and mass transfer, heat exchanger core, temperature drop rate, cooling efficiency

CLC Number: 

  •  
[1] . Preparation and photocatalytic degradation and decolorization performance of TiO2-rGO composites [J]. Journal of Textile Research, 2018, 39(12): 78-83.
[2] . Analysis of transient characteristics of magnetic latching needle selector based on Ansys [J]. Journal of Textile Research, 2018, 39(12): 124-130.
[3] . Design of three-dimensional complex shaped overall braiding chassis device [J]. Journal of Textile Research, 2018, 39(12): 107-112.
[4] . Low temperature plasma treatment of basalt fiber surfacce and its sizing strand integrity [J]. Journal of Textile Research, 2018, 39(12): 24-29.
[5] . Preparation and sizing properties of microwave assisted carboxymethyl corn starch [J]. Journal of Textile Research, 2018, 39(12): 59-66.
[6] . Conductivity and molecular simulation of wool fabrics finished by polyaniline/chitosan [J]. Journal of Textile Research, 2018, 39(12): 95-100.
[7] . Preparation of multifunctional nanofibers by microfluidic spinning technology and its application [J]. Journal of Textile Research, 2018, 39(12): 158-165.
[8] . Bionic horizontal branching structure of PEG/PP microfibers material and liquid diffusion properties in horizontal direction [J]. Journal of Textile Research, 2018, 39(12): 18-23.
[9] . Properties of washable and graphene conductive silk with in-situ reduction method [J]. Journal of Textile Research, 2018, 39(12): 84-88.
[10] . Chitosan based nanofiber drug loaded system and its sustained release behavior [J]. Journal of Textile Research, 2018, 39(12): 7-12.
[11] . Fabrication of polylactic acid tree-like nanofiber and its application in filtration [J]. Journal of Textile Research, 2018, 39(12): 139-144.
[12] . Nonisothermal crystallization kinetics of novel nylon-carbon chain polyamide 1211 [J]. Journal of Textile Research, 2018, 39(12): 1-6.
[13] . Preparation and properties of waste textile regenerated felt materials [J]. Journal of Textile Research, 2018, 39(11): 56-60.
[14] . Design on pressure compatibility model of evenness roll [J]. Journal of Textile Research, 2018, 39(11): 158-162.
[15] . Customization of sports bra cup based on 3-D printing [J]. Journal of Textile Research, 2018, 39(11): 135-139.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] WU Jun;WEN Shengjun. Application of BP nerve network in suit pattern design[J]. JOURNAL OF TEXTILE RESEARCH, 2008, 29(9): 113 -116 .
[2] . Preparation and photocatalytic degradation and decolorization performance of TiO2-rGO composites[J]. Journal of Textile Research, 2018, 39(12): 78 -83 .
[3] . Preparation and property of waterproof breathable nano silicon dioxide microspheres / poly-ether block amide coating fabric[J]. Journal of Textile Research, 2018, 39(10): 104 -109 .
[4] . Preparation and application of antimicrobial mug wort oil-chitosan microcapsules[J]. Journal of Textile Research, 2018, 39(10): 99 -103 .
[5] . Inspection of remaining yarn on bobbin based on odd Gabor filters[J]. Journal of Textile Research, 2018, 39(10): 138 -142 .
[6] . Shape and structure characteristics of female jacket in the Mid and Late Ming Dynasty[J]. JOURNAL OF TEXTILE RESEARCH, 2017, 38(09): 115 -119 .
[7] . Working mechanism of warp knitting yarn tension compensator [J]. Journal of Textile Research, 2018, 39(11): 140 -144 .
[8] . Design of 3-D woven fabric selvage modeling process[J]. JOURNAL OF TEXTILE RESEARCH, 2017, 38(04): 50 -54 .
[9] . She’s costumes heritage context in Zhejiang and Fujian provinces based on ethnic migration history[J]. JOURNAL OF TEXTILE RESEARCH, 2017, 38(04): 115 -120 .
[10] . Dyeing properties of difluorenylidene quinoidal thiophene dye on cotton fabric[J]. Journal of Textile Research, 2018, 39(10): 81 -85 .